Paper Holder Is the Rage
2008-08-19

Nowadays, you can see that paper holder is widely used in the bathroom, living room and everywhere in the room with a wide variety of shapes, colors and materials. Paper Holder is all the rage.

Unique toilet paper holder accessorizes a well-appointed master bath, guest bathroom, or powder room.

How is a paper holder made up of?

A paper holder consists of a shell, the inner paper-cut and paper-feed devices and components.

Its identity within the shell of the paper-cut-axis sets, paper-cut shelves are symmetrical two sliding seat, sliding seat with rack, rack fixed in the activities of the shelves.

The shelves activities also fixed two rubber compression and paper-cut, and paper-cut side of the front end also fixed a contact spring, spring on the block in contravention of rotation can handle contacts within the framework of paper-cut package in the case of live-axle, when the paper-cut-rotation, the rack and pull paper pressure round of the meshing of gears.

Handle under pressure driven feed device on the gear of the rotation, so that tissue-paper-cut running through the pros and cons of rubber in the film, when the handle contacts with the touch of spring block contacts, to handle the pressure, together with the activity rack.

Paper cutting knife moves forward, cutting paper towels.

Toilet Paper Holder

Toilet paper holder is an important facet of European bathroom design, now it’s widely used everywhere in the world. People pay more attention to toilet paper holder, including the materials, shapes, installation and so on.

It is usually made of plastic, stainless steel and other synthetic materials. With the high development of technology and information, it is more durable and its shape and color changes a lot, which are stylish and fashion.

Installing a toilet paper holder

1. You should gather up all the components, including hammer, cordless drill, small lever, screws, toilet paper.

2. Measure the length of the toilet paper. In order for the spring-loaded roll holder to function, the two brackets must be precisely spaced.

3. Position one bracket make it level, and mark the holes. Next you should drill small pilot holes in the vanity so the screws would go in easily.

4. Drive the screws in with a cordless drill, place the other bracket beside the first, finally mark and drill the holes.

5. Install the second bracket in the same way and install the paper to test the fit. 

6. The accessory kit comes with small plugs to cover the screw holes. Just push the plug into the hole and give it a tap.

Other tips

1. Do you know the standard height for a toilet paper holder for comfort height taller toilets?

The answer is 24" from the floor, which is a good starting point. If the toilet is close to a wall or vanity you may want to increase the measurement to 30" to provide some extra clearance for "large" people.

2. How far from the rear wall should a toilet paper holder be placed?

Just put it wherever is most accessible and convenient. There is no set distance.